GAS CYLINDER - PISTON WITH BUSH - MAGAZINE TUBE CAP SHAFT Oil it lightly by passing a clean soft cloth soaked with Beretta oil or an equivalent through the barrel. Pass another clean soft cloth through the barrel. After some use carefully clean the inside of the barrel by passing a soft cloth (flannel) through the barrel in order to remove combustion residues. If any should be necessary it should be entrusted to a competent gunsmith. It is not advisable to carry out any further disassembly of the shotgun. Keeping the cartridge latch button pressed, slide the trigger plate forward and downwards (ill. Detach the trigger plate retaining pin A3 by pressing with the point of a drift or some other pointed object (ill. Press in carrier stop push-button A6 (ill. breech bolt assembly, locking block, firing pin extractor. breech bolt slide with connecting rod and pin The breech bolt assembly no longer held by the action bar will divide into its two main components (ill. Hold the stock receiver assembly on a flat surface, with the feeding port facing upward, with the left hand with the right hand grasp the operating rod H and slide it forward off the magazine tube to detach the breech bolt assembly from the receiver (ill. Remove the cocking handle with a jerk (ill. Holding the cocking handle with the index or middle finger of the left hand, press the cartridge latch button and allow the breech bolt to slide slowly to a rest (ill. Grasping the barrel at the height of the gas cylinder, hold the piston inside the gas cylinder with the right thumb to prevent dropping it slide barrel assembly forward off stock-receiver-fore-end assembly (ill. Slide the fore-end forward off magazine tube. Unscrew (anticlockwise) and remove the fore-end cap. Pull back the breech bolt (see point c5). If weapon is not supplied with the cut-off device, follow instructions given in points f4, f5, f6, f7. f2, f3, when the gun is supplied with the cut-off optional device. If it is not unloaded, unload the gun following the instructions given in points fl. Make sure that the gun is unloaded (chamber empty, magazine tube empty).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
February 2023
Categories |